Instructions for the assembly of the bracket download here...

a)  Position the bracket (1) as indicated on the drawing and insert the cover (2) into the upper hole, the joint (3) and the spherical pin (4).

b)  Screw the screw (5) to the bottom of the spherical pin (4), without tightening the screw.

c)  Rotate the pin (4) until the slot (6) fits in the mark (7) placed on the bottom of the bracket.

d)  Tighten the screw (5)

PRESCRIPTIONS FOR THE INSTALLATION

a)  Fasten the braCket to the wall with 4 expanding bosses by using the 4 holes of the basis of the bracket. The special arrangement and shape of the holes allows to correct small mistakes of the drilling of the wall.

b)  Ensure that the bosses and the wall are strong enough to hold the complete configuration consisting oF bracket, housing and camera. Please note that inadequate bosses or weak support walls could lead to the falling down of the bracket with the housing and may cause damage to persons.

c)  Fasten the housing to the bracket with the two holes of the joint (3). The fastening screws are delivered with the housing.